Filter
Top Products
GB 9
Connecting the Mediamaster
Connecting to the TV without SCART
• Remove the aerial lead from your TV and connect this to the
TV AERIAL input socket on the Mediamaster.
• Connect an RF cable from the TV/VCR output on the Media-
master to the RF input socket on the TV.
• Switch on your TV, plug in and switch on your Mediamaster.
• Select a programme number on the TV that is not currently
used for other TV channels.
• Follow the instructions in your TV manual to tune the TV to pick
up the First time installation menu.
• Follow the instructions in your TV manual to store this chan-
nel.
• When the First time installation menu is visible, press the se-
lect button on the Mediamasters remote control to start the
installation procedure.
If the picture quality is bad you can later change the predefined
UHF channel 43 to any other figure between 21 and 69. You will
also have to tune your TV to the same (= the new) channel
number. Please see RF modulator output channel setting on
page 20.
RF
Connecting a HiFi system
• Connect an RCA/Cinch stereo cable ( phono ) from the AUDIO
L R sockets on the Mediamaster to the LINE, -IN, AUX, SPARE
or EXTRA input sockets on your HiFi system.
• If available you can connect an RCA/Cinch single cable from
the DIGITAL AUDIO socket on the Mediamaster to a HiFi sys-
tem equipped with digital audio input. This output is also used
for connection to an external Dolby™ digital decoder.
Note: To avoid interference you must use screened audio
cables. Never connect digital output to any analogue input.
It is always advisable to consult your HiFi instruction book.