Filter
Top Products
GB 2
Important Information
Wiring the plug (UK and Eire only)
The mains lead on this product is already fitted with a non-rewireable (moulded) plug
incorporating a fuse, the value of which is indicated on the pin face of the plug. Should
the fuse need to be replaced, an ASTA or BSI approved BS 1362 fuse must be used of
the same rating, marked thus:
If the fuse cover is detachable always refit the cover after replacing the fuse. NEVER
use the plug with the fuse cover omitted. If the fitted plug is not suitable for your socket
outlets it should be cut off, after having first removed the fuse, and an appropriate plug
fitted in its place. If this new plug contains a fuse its value should be the same as that
removed from the non-rewireable plug.
The severed plug must be destroyed immediately to avoid the possible shock hazard
should be inserted into a 13A socket elsewhere.
If you need to replace the mains plug then follow the instruction given below:
The wires in the mains lead are coloured in accordance with the following code:
BLUE - Neutral (N); BROWN - Live (L).
As these colours may not correspond with the coloured markings identifying the ter-
minals in your plug, proceed as follows:
The wire coloured BLUE must be connected to the terminal marked with the letter N
or coloured BLUE or BLACK. The wire coloured BROWN must be connected to the
terminal marked with the letter L or coloured BROWN or RED. On no account either
of these wires to the terminal marked E or coloured GREEN or GREEN and YELLOW.
Before replacing the plug cover, make certain that the cord grip is clamped over the
sheath of the lead; not simply over the two wires.
If in doubt, consult a competent electrician.
We reserve the right to change specifications.
Please be aware that new software can change
the functionality of the Box.