Filter
Top Products
Transmitter Functions
LOCK BUTTON
Pressing the LOCK button will
lock all of the doors and engage
the optional starter interrupt;
when held operates “Panic”.
GREEN LIGHT
Illuminates whenever any transmitter
button is pressed.
III BUTTON
Pressing the III button for two
seconds can be used to activate
the 3rd Channel Output. This
Button may also be configured
to activate the “Panic” feature.
II BUTTON
Pressing the II button for 2 seconds
will activate remote trunk release
(vehicle must be equipped with
power trunk release). This
operation also unlocks the doors.
Your system may be configured to
lock your doors upon turning the
ignition "On", and unlock them
when the ignition is turned "Off".
UNLOCK BUTTON
Pressing the UNLOCK button
will unlock all of the doors and
disengage the starter interrupt
circuit. Or, if the system is thusly
configured, pressing the
UNLOCK button
once unlocks
only the driver's door and
pressing a second time will
unlock all of the doors. Press
and hold to activate “Panic”.
Your system is capable of being
operated by up to four transmitters,
which are available from where you
purchased your system.
Page 18
14) Transmitter Activated Anti-Carjacking: Default OFF.
This Feature adds Anti-Carjacking protection, and the ignition must be "on" for the Anti-
Carjacking to operate. Press and hold the transmitter's II button for 3 seconds. The piezo will
start beeping 53 seconds later, and for the next seven seconds pressing the Valet Switch once
will cancel the Anti-Carjacking Feature. At 60 seconds the piezo starts making a siren sound,
and the parking and dome lights will also flash. At 90 seconds the starter interrupt output will
activate. Once the siren sound occurs and lights flash, Anti-Carjacking cannot be canceled
unless the ignition is turned "off", then back "on"; the Valet Switch must be pressed once
within 10 seconds of turning the ignition back "on". This is the only way to cancel or turn off
the Anti-Carjacking Feature - once activated, the transmitter cannot be used to cancel or turn
off the Feature.
15) 30 Second Parking Lights Upon Unlock: Default 30 Seconds.
This feature gives the option of having the parking light output flash twice then illuminate
for 30 seconds upon Unlock or have the parking lights only flash twice upon Unlock. To
change this feature press the Lock button for the 2 flashes only setting.
16) “Panic” or 3rd Channel From Button III: Default 3rd Channel.
This feature allows button III to operate either “Panic” or 3rd channel. In the default setting
holding button III depressed for 4 seconds will activate the 3rd channel output. Panic can
be activated from either the lock or the unlock button. Press and hold either button for 5
seconds to activate panic. With this feature off press and hold button III for 5 seconds to
activate “panic”. Press the lock and unlock buttons together for 5 seconds to activate the
3rd channel output.
Page 3