Filter
Top Products
Page 5
LED Off......................................................................Ignition switch is "On" OR the system
is "at rest", indicating that no automatic
features will occur.
LED On Solid Red .....................................................System is in "Valet Mode".
LED Flashing Rapidly................................................An automatic function countdown is in
progress.
LED Flashing Slowly .................................................Starter Disable is engaged. This will occur
whenever the transmitter is used to lock the
doors. The Starter Disable may also be
programmed to operate automatically.
LED Flashes 1 To 4 Times After Ignition "On" ........Number of transmitters stored in the system.
These four indicators are part of the Auto-
matic Transmitter Verification
TM
feature.
The REC-11 includes a piezo buzzer for audible confirmation when a transmitter command is
received: one beep acknowledges a LOCK command and two beeps acknowledge an UNLOCK
command. If the system is in Valet Mode, the piezo buzzer will also beep once when the ignition is
Audible Confirmation
Page 16
transmitter has been used to unlock them. Turning the ignition "on" during the 90 second
period will cancel the automatic relocking.
4) Doors Lock With Ignition "On": Default ON.
5) Ignition "Off" Unlock #1: Default ON.
6) Ignition "Off" Unlock #2: Default ON.
These three Features control the doorlocks in relation to the ignition being turned on or off.
7) Operating Trunk Release Also Unlocks Doors: Default ON.
When the transmitter's II button is pressed for 3 seconds to activate the Trunk Release
output, this Feature will unlock the doors. Both doorlock unlock outputs will operate.
8) Doorlock Pulse Time .8/3 Seconds: Default .8 Second (press LOCK).
Some vehicle's power doorlocking systems (example: Mercedes Benz pneumatic systems)
require a longer output pulse to operate properly. This Feature allows the installer the
flexibility to accommodate such systems.
9) Double Unlock Pulse: Default OFF.
This is another Feature provided for the installer's benefit. Some newer vehicles require a
double pulse to remotely unlock the doors and/or to disarm a factory-equipped security
system.
10) Confirmation Chirps: Default ON.
This Feature causes the system to acknowledge the reception of a transmitter command.
Pressing LOCK produces one beep; pressing UNLOCK produces two beeps. Turning this
Feature OFF silences the confirmation beeps.