Filter
Top Products
Page 6
turned "off" as a reminder. Single beeps will also accompany the engagement of automatic locking
and starter interrupt circuit engagement. This confirmation can be from the included piezo or the
vehicles’ horn.
Automatic Transmitter Verification
TM
The REC-11 has built-in relays which illuminate the vehicle's parking and dome lights to provide
a visual confirmation of the system's operations. The parking and dome lights will:
Flash Once ..................................................................Doors have locked by using the transmitter.
Flash Twice Then Stay On 30 Seconds......................Doors have unlocked by using the transmitter.
The parking and dome lights staying on for 30 seconds after the transmitter's use has unlocked the
doors illuminates your way to the vehicle when dark and also allows inspection of the interior.
Visual Confirmation
You received two remote control transmitters to operate your Remote Keyless Entry System.
The system LED will flash two times every time the ignition key is turned “on”. This alert will last
90 seconds for the first 48 hours after a new installation. The alert will shorten to 10 seconds after the
first 48 hours. If a new remote is coded into the system the alert will again be 90 seconds for 48 hours.
This Patented feature alerts you if someone has covertly added an unauthorized transmitter to your
system, and is found only in Omega Research and Development products.
Page 15
turn features off. The module will acknowledge turning the Feature "on" by beeping once,
or "off" by beeping twice. If 10 seconds of no programming activity expires (not pressing
the LOCK or UNLOCK buttons or selecting another Feature) the system will exit the Features
Programming Mode, which is indicated by sounding the piezo buzzer for a short period.
The 17 Programmable Features, their factory-set default settings, and the transmitter button
pressed during programming to obtain the default setting are as follows:
1) Secret Override Code: Default 1 & 0 Programming Switch Press.
As explained in the "Valet Switch" section of the operations guide, only one press of the
Valet Switch is required to Override the system. However, if a more secure starter interrupt
circuit Override is desired, the number of Valet Switch presses may be custom-programmed
to achieve the Override Mode. To change the system from the default setting, follow Steps 1,
2, and 3 on the previous Page. At Step 4, press and release the transmitter's LOCK button a
number of times equal to the desired new code to enter the Override Mode. The system will
respond to each transmitter button press with a piezo beep. After pressing the transmitter
button the desired number of times, wait for the system to beep the same number. A second
stage may now be entered, if desired, by pressing the transmitter's UNLOCK button in a
similar fashion.
2) Doors Automatically Lock 90 Seconds After The Ignition Is Turned "Off": Default
OFF. Activating this Feature will cause the doors to automatically lock 90 seconds after the
ignition switch is turned "off".
3) Doors Automatically Relock 90 Seconds After Remotely Unlocking: Default OFF.
Activating this Feature will cause the doors to automatically relock 90 seconds after the