Filter
Top Products
OWNER’S MANUAL
Changing Volume Lock 15
CHANGING VOLUME LOCK
The One For All 6L Universal Remote
Control with Learning (URC-6820 B00) is
set at the factory for independent volume
control of each selected device.
However, you may change the Volume Lock
setting to Global Volume Lock so that a
device’s volume will be locked to one mode
(e.g., to control TV volume in all other
modes). After that, if desired, you can
perform Individual Volume Unlock on a
selected device to set its volume control for
independent operation.
LOCKING VOLUME CONTROL TO ONE MODE
(GLOBAL VOLUME LOCK)
1. Press and hold SET until the LED (red
light) blinks twice, then release SET.
2. Enter 9 9 3 and then press any mode
key once (e.g., TV). The LED will blink
twice.
3. Now, when you press VOL +, VOL -, or
MUTE, the volume of the selected
device (e.g., TV) will be controlled
regardless of the mode you have
selected.
UNLOCKING VOLUME CONTROL FOR A
SINGLE DEVICE (INDIVIDUAL VOLUME
U
NLOCK)
1. After performing Global Volume Lock
(see left), press a desired mode key
where you want volume to be unlocked
(e.g., AUD) and controlled within its
own mode.
2. Press and hold SET until the LED (red
light) blinks twice, then release SET.
3. Enter 9 9 3 and then press VOL - once.
The LED will blink four times.
4. If desired, repeat steps 1 through 3 (of
this section) for each device that you
want volume to be unlocked.
5. Now, after you select a device that has
volume unlocked (e.g., AUD), pressing
VOL +, VOL -, or MUTE, will control the
device’s volume only in its own mode.
UNLOCKING ALL VOLUME CONTROL
(RESTORING DEFAULT SETTING)
NOTE: Performing these instructions will
restore independent volume control for all
programmed devices (e.g., TV volume
control in TV mode, VCR volume in VCR
mode, etc.).
1. On the remote control, press and hold
SET until the LED (red light) blinks
twice, then release SET.
2. Enter 9 9 3 and then press VOL + once.
The LED will blink four times.
3. Volume will again be independently
controlled according to its default
states for all programmed devices.
RESTORING FACTORY
DEFAULT SETTINGS
The One For All 6L Universal Remote
Control with Learning (URC-6820 B00)
includes a Setup Code Reset program. You
can use it to restore all your programmed
codes to factory settings and delete all
custom programming.
IMPORTANT: Executing this program
erases all code settings and all custom
settings including, Macros, Learned Keys,
Reassigned Device Keys, Keymoved Keys,
Favorite Channels, and all device
settings.
OFA 6L with Learning Owners Manual.fm Page 15 Thursday, February 17, 2005 1:10 PM