Filter
Top Products
Batteries
Your ONE FOR ALL 1 Remote needs 2 new "AA/LR6" Alkaline batteries.
1 Push the battery door upwards and lift it up to remove it.
2. Match the batteries to the (+) and (–) marks inside the battery case,
then insert the batteries.
3. Replace the battery cover by pushing downwards and allowing
it to click back into position.
Please refer to the picture of the ONE FOR ALL 1 Remote Control on
Page 3.
1 Magic Key:
The Magic key is used to set-up your ONE FOR ALL 1 Remote Control
and to access special functions.
2 LED:
During the use of your ONE FOR ALL 1, the LED will light up red.
3
Power Key:
The Power key controls the same function as it did on your original
remote.
4 Number Keys:
The Number keys (0-9, -/--(10)) provide the functions just like your
original remote, such as the direct access to program/channel
selection. If your original remote uses a 10 key, this function can be
found by pressing the -/-- key.
5 AV
The AV key operates the same function it did on your original
remote control.
6 Channel Up / Down Control:
These keys control the same functions as your original remote
control.
7 Mute Key:
The Mute key operates the same function it did on your original
remote.
8 Volume Up / Down Control:
These keys operate just as those on your original remote.
9 Directional Keys
If available on your original remote, these keys will allow you to
navigate through the menu of your device.
10
OK key
If your original remote control required that you press an “OK” or
“ENTER” key during Menu operation, this key can be used for this
function.
The Keypad
- In order to avoid having to re-program your ONE FOR ALL 1
after you remove the batteries, you will need to insert new
batteries within 5 minutes. Also it is recommended that you
do not use rechargeable batteries.
- On the inside of the battery compartment door you will find
a label on which to write your Set-Up Codes for future
reference. This you will do after setting up your ONE FOR
ALL 1 remote for your devices.
WWW.ONEFORALL.COM 4