Filter
Top Products
WWW.ONEFORALL.COM 9
Problem & Solution
Problem:
Your brand is not listed
in the code section?
The ONE FOR ALL 1 does
not operate your
device(s)?
The ONE FOR ALL 1 is not
performing commands
properly?
Problems changing
channels?
The ONE FOR ALL 1 does
not respond after
pressing a key?
The red light (LED) does
not blink when you press
a key?
Solution:
Try the search method on page 7.
A) Try all the codes listed for
your brand.
B) Try the search method on
page 7.
You may be using the wrong
code. Try repeating the Direct
Set-Up using another code listed
under your brand or start the
search method over again to
locate the proper code.
Enter the program number
exactly as you would on your
original remote.
Make sure you are using new
batteries and are aiming the ONE
FOR ALL 1 at your device.
Replace batteries with 2 fresh,
new “AA/LR6” alkaline batteries.
Depending on the functions of your original remote control, the ONE FOR
ALL 1 may operate the colour and brightness settings of your television.
Colour (+) = Press and release MAGIC then hold Volume (+)
Colour (-) = Press and release MAGIC then hold Volume (-)
Brightness (+) = Press and release MAGIC then hold Channel (+)
Brightness (-) = Press and release MAGIC then hold Channel (-)
Colour and Brightness
Trouble Shooting