Filter
Top Products
REMOTE
CONTROL
ININ
IN
IN
IN
COAXIAL
OPTICAL
IN
IN
IN
IN
FRONT
SURR
CENTER
SUB
WOOFER
VIDEO 2
VIDEO 1
OUT
IN
IN
OUT
OUT
OUT
DIGITAL INPUT
VIDEO 2VIDEO 3
VIDEO 1
DVD MONITOR
OUT
VIDEO
S VIDEO
DVD
TAPE
CD
L
R
IN
VIDEO 3
L
R
ANTENNA
FM
75
AM
SUBWOOFER
PRE OUT
DIGITAL
OUT
COAXIAL
S VIDEO
OUT
VIDEO
OUT
L
R
S VIDEO
OUT
VIDEO
OUT
FRONT
Enjoying DVD
1.
Connect the monitor TV and the DVD player.
Here, only the typical connections are shown. For details, see pages 10 and 11 of the main
manual.
2.
Connect the power cord to a wall outlet.
3.
Turn on the power.
The STANDBY indicator turns off, and the display area lights up.
Make sure that the power switch on the DVD player is also turned ON.
4.
Select the speaker system(s) to be used.
5.
Set the Input Select to DVD.
6.
If you connect the digital output jack of the DVD player to the COAXIAL jack on
the HT-R410 in step 1, proceed to step 7. If you connect to the OPTICAL jack on the
HT-R410, perform the following settings.
1 Press the DIGITAL INPUT button on the HT-R410.
The default DVD setting (Coaxial) appears.
2 Press the DIGITAL INPUT button repeatedly to select “Optical”.
7.
Play a DVD.
The video appears on the monitor TV.
In the following cases, you can control an Onkyo DVD player using the remote controller
of this unit.
• When an Onkyo DVD player is z-connected.
(See page 16 of the main manual for details.)
• When the manufacturer’s code is entered.
(See pages 33-34 of the main manual for details.)
How to play a DVD using the remote controller:
1 Press the CD/DVD button.
2 Press the s button.
8.
Adjust the volume.
9.
Select the listening mode.
The selectable listening mode varies depending on the source. (See pages 28–29 of the
main manual for details).
10
.
Select the audio mode.
You can compare the analog and digital sound. (See page 26 of the main manual for
details).
DVD player
:Signal flow
Note
Note
TV or projector
The STANDBY indicator lights up.
Wall outlet
To enjoy multi channel input See page 27 of the main manual.
To retain better sound effect, we recommend to make the following settings.
“Connecting speakers”
See pages 12–13 of the main manual.
“Speaker Setup”
See pages 18–20 of the main manual.
Note
Either the S-Video or Video terminal
can be used for connection. However,
the type of the terminals used in
connection between the DVD player
and this unit should be identical to that
used in connection between the TV and
this unit.
3
9
5
4
7
-1
7-2
10
8