Onkyo HT-R410 Universal Remote User Manual


  Open as PDF
of 4
 
REMOTE
CONTROL
ININ
IN
IN
IN
COAXIAL
OPTICAL
IN
IN
IN
IN
FRONT
SURR
CENTER
SUB
WOOFER
VIDEO 2
VIDEO 1
OUT
IN
IN
OUT
OUT
OUT
DIGITAL INPUT
VIDEO 2VIDEO 3
VIDEO 1
DVD MONITOR
OUT
VIDEO
S VIDEO
DVD
TAPE
CD
L
R
IN
VIDEO 3
L
R
ANTENNA
FM
75
AM
SUBWOOFER
PRE OUT
DIGITAL
OUT
OPTICAL
L
R
AUDIO OUT
(PLAY)
CD player
Enjoying CD
1.
Connect the CD player.
2.
Connect the power cord to a wall outlet.
3.
Turn on the power.
The STANDBY indicator turns off, and the display area lights up.
Make sure that the power switch on the CD player is also turned ON.
4.
Select the speaker system(s) to be used.
5.
Set the Input Select to CD.
6.
If you connect the digital output jack of the CD player to the OPTICAL jack on the
HT-R410 in step 1, proceed to step 7. If you connect to the COAXIAL jack on the
HT-R410, perform the following settings.
1 Press the DIGITAL INPUT button on the HT-R410.
The default CD setting (Optical) appears.
2 Press the DIGITAL INPUT button repeatedly to select “Coaxial”.
7.
Play a CD.
When an Onkyo CD player is z-connected, you can control an Onkyo CD player using
the remote controller of this unit.
You need to enter the manufacturer’s code “300”. (See pages 33–34 of the main manual
for details.)
How to play a CD using the remote controller:
1 Press the CD/DVD button.
2 Press the s button.
8.
Adjust the volume.
9.
Select the listening mode.
The selectable listening mode varies depending on the source. (See pages 28–29 of the
main manual for details).
10
.
Select the audio mode.
You can compare the analog and digital sound. (See page 26 of the main manual for
details).
The power turns on but no sound is heard.
The MUTING indicator flashes.
Press the MUTING button on the remote controller to turn off the
MUTING indicator
The headphones are connected.
Disconnect the headphones.
The connections are incorrect.
Make sure that all connections are made correctly.
The digital input setting is incorrect.
Make sure that correct input source is set in step 6 above.
The power does not turn on.
The connections are incorrect.
Make sure the power cord is connected correctly.
The external noise has affected the internal .
Unplug the power cord from the AC outlet to turn off the unit and then
plug it again after about five seconds.
If no sound is heard.
3
9
4
7
-1
7-2
5
10
8
 previous