Filter
Top Products
41
SN 29343150 DV-L5E
■ DTS Out
This player is capable of outputting DTS digital audio for DVDs
recorded in DTS. When this player is connected to an AV
component that has a built-in DTS decoder, select [DTS]. If
your system is not equipped to decode DTS, select [Off]. Refer
to the operating instructions supplied with your audio
components if you are unsure about compatibility with DTS.
—
—
—
—
V2Video1
General
Language
Exit
Move
Audio DRC
Dolby Digital Out
DTS Out
96kHz PCM Out
MPEG Out
Audio
Off
Dolby Digital
Off
DTS
MPEG 3 PCM
Change DTS output mode
SETUP
—
—
—
—
SETUP
V2Video1
General
Language
Exit
Move
Audio DRC
Dolby Digital Out
DTS Out
96kHz PCM Out
MPEG Out
Audio
Off
Dolby Digital
Off
96kHz 3 48kHz
96kHz
Change 96kHz output mode
■ MPEG Out
This player is capable of outputting the MPEG digital
bitstream. When the player is connected to an AV component
that has a built-in MPEG decoder, select the [MPEG] setting.
Otherwise, select [MPEG 3 PCM] to convert the digital signal
to the PCM signal, the digital signal output from a CD.
—
—
—
—
—
SETUP
V2Video1
General
Language
Exit
Move
Audio DRC
Dolby Digital Out
DTS Out
96kHz PCM Out
MPEG Out
Audio
Off
Dolby Digital
Off
MPEG
MPEG 3 PCM
Change MPEG audio output mode
—
—
—
—
—
—
V2Video1
General
Language
Exit
Move
Audio DRC
Dolby Digital Out
DTS Out
96kHz PCM Out
MPEG Out
Digital Out
Audio
Off
Dolby Digital
Off
96kHz 3 48kHz
MPEG 3 PCM
On
Off
SETUP
Settings: Off (Factory setting)
DTS
Note
If you have made digital audio connections to component(s) not
equipped to decode the DTS digital bitstream, be sure to select [Off].
If a DTS signal is output without decoding, the output is digital noise
that could potentially cause damage to your speakers.
■ 96 kHz PCM Out
This player is capable of outputting digital signals with a
sampling frequency of 96 kHz. If you have made connections
to a component capable of processing this signal rate, select
[96 kHz] for the signal to be output as is. As some components
are incapable of processing digital signal input with sampling
rates of 96 kHz, selecting [96 kHz 3 48 kHz] compresses the
signal to a standard signal with a sampling rate of 48 kHz.
Settings: 96 kHz 3 48 kHz (Factory setting )
96 kHz
Note
On DVDs that contain copy protection, the 96 kHz signal may only
be output from the analog audio jacks.
Settings: MPEG
MPEG 3 PCM (Factory setting)
■ Digital Out
Expert
Depending on your preferences and the type of connections
made, you may opt not to have the digital audio signal output
at all. When this setting is set to [Off] there is no signal output
from the digital audio output jacks.
Make changes to the [Digital Out] setting in the Setup screen
Audio menu in the [Expert] menu mode (page 39).
Settings: On (Digital bitstream is output) (Factory setting)
Off (Digital bitstream is not output)