Filter
Top Products
14
OPERATION
USING THE REMOTE
CONTROL
The control buttons on the remote con-
trol are identical to those on the front of
the VCP. To use the remote control, be
sure that the front end of it is pointing
with a clear path toward the front of the
VCP, then press the desired button(s).
PLAYING A VIDEO TAPE
1. Press
POWER
to turn on the VCP.
The red POWER indicator lights
steadily.
2. Turn on the TV/monitor. If you are
using a standard TV, tune it to the
same channel (3 or 4) to which you
set the VCP’s
CHANNEL
switch. If
you are using a TV monitor, switch it
to the video setting.
3. To load a video cassette tape, insert
the tape halfway into the VCP’s cas-
sette door with the main label facing
up and the spine label facing out.
Then gently push on the center of
the tape’s spine until the VCP pulls
the tape all the way in. TAPE IN then
PLAY lights steadily, and the tape
automatically begins to play.
4. To stop the tape during play, press
STOP
. PLAY turns off and the tape
stops.
Note
: To start playback again, press
PLAY(x2)
.
16-419.fm Page 14 Tuesday, July 20, 1999 11:16 AM