Filter
Top Products
Connection to an Audio System
Connections
Recording
Playing discs EditingBefore you start Connections Getting started
Changing the SETUP menu
Others Español
15
• When you change the connections, all devices should be turned off.
• Refer to each owner’s manual for further information on other devices.
or
Stereo system
COAXIAL
AUDIO
Method 1
Analog audio
input jacks
Digital audio
input jack
AUDIO OUT
DIGITAL
AUDIO OUT
Method 2
Audio cable
(supplied)
Audio Coaxial
Digital cable
(commercially
available)
Note
• If output is Dolby Digital encoded audio, connect to a
Dolby Digital decoder, and set “Dolby Digital” to
“Stream” for the “Digital Out” setting in the SETUP
menu. (Refer to pages 88-89.)
• The audio source on a disc in a Dolby Digital 5.1 channel
surround format cannot be recorded as digital sound by
an MD or DAT deck.
• Unless connected to a Dolby Digital decoder, set “Dolby
Digital” to “PCM” for the “Digital Out” setting in the
SETUP menu. Playing a DVD using incorrect settings may
generate noise distortion, and may also damage the speak-
ers. (Refer to pages 88-89.)
• Set “Dolby Digital” to “PCM” for the “Digital Out” set-
ting in the SETUP menu for connecting to an MD deck
or DAT deck. (Refer to pages 88-89.)
• By hooking this unit up to a Multi-channel Dolby Digital
decoder, you can enjoy high-quality Dolby Digital 5.1
channel surround sound as heard in the movie theaters.
Dolby Digital decoder,
MD deck or DAT deck
DVD Recorder
E6501UD_DVR90DEA.qx3 04.3.17 16:27 Page 15