Filter
Top Products
8
EN
I
NTRODUCTION
Attaching a Wall Mount Bracket (sold separately)
The following is a description of the method for attaching a wall mount to this unit.
When performing this operation, refer to the instruction manual included with the wall mount kit.
#
CAUTION
• Any damage caused by incorrectly attempting to mount this unit is not covered under the terms of the manufacturers warranty.
• This unit may be used only with VMFb manufactured by CSAV.
• Use with other wall mounts may result in instability causing possible injury.
You need the following wall mount kit for this unit.
Vision Mount LCD Mounts
Model number: VMFb
For more information, please visit CSAV website at www.csavinc.com
5
1
Turn this unit over and place it screen-first onto a table
which has a soft cloth draped over it.
Place this unit in a way so that the stand hangs over
the edge of the table.
Note:
• Make sure to use a table which can support the weight of this
unit and is larger than this unit.
• Make sure the table is in a stable location.
2
Remove the stand from this unit.
Unscrew the M4 screws indicated by
1
and remove the
stand. Please be careful with the unit after you remove
the stand.
Note:
• The M4 screws and stand you have removed are necessary
for reattachment at a later date. Make sure to keep them in a
safe place.
3
Attach the monitor plate to this unit using the 4 bolts
included with the wall mount kit.
You do not need to use the lock washers for mounting
this unit.
Note:
• Only use the screw holes indicated by
2
for mounting this
unit.
• For instructions on how to attach the monitor plate, refer to
the instruction manual included with the wall mount kit.
4
Attach this unit to the wall.
Note:
• Refer to the instruction manual included with the wall mount
kit when securing this unit to the wall.
* If you want to attach the stand of this unit again,
insert the stand slowly as illustrated below and drive
M4 screws in the 4 threaded holes (
1
).
VIDEO 2
AUDIOCOMPONENT
VIDEO 1
ANT
AUDIO
LR
LVIDEOS-VIDEO
COAXIAL
PrPbY
R
HEADPHONE
2
rear of this unit
1
1
stand
* 1 and 2 indicate the
position of the screw holes
on this unit.
1