Filter
Top Products
INSTALLING BATTERIES :
* Take care not to drop, dampen, disas-
1. Remove the battery cover of Remote
semble the Remote Control Unit.
Control Unit.
* Operatable remote control range is
2. Insert two "AAA" 1.5V batteries making
limited as shown.
sure the polarity (+ or -) of the batteries
matches the polarity marks inside the
unit.
3. Close the battery cover.
* When the Remote Control Unit is not
used for a long time or the batteries are
worn out, take out the batteries to
prevent electrolyte leakage.
OPERATING INSTRUCTIONS:
ANTENNA CONNECTIONS
Optimum colour reception requires a good antenna. An out-door antenna will be more
effective to obtain a clear-picture.
Insert the out-door antenna into the antenna socket on the cabinet back. Adjust the direction
or position for the best possible picture.
When there is no outdoor antenna, an indoor antenna fixed in the back-upper of the cabinet
will help you, adjust the direction and angle to get the cleat-picture.
POWER SUPPLY AND STANDBY BUTTON
The set can operate with AC 240V or 12V DC
AC POWER SUPPLY
1. Plug the AC power adaptor of the AC-POWER ADAPTOR to an outlet supplying AC
240V the indicator is red, plug the DC power cord of the AC-POWER ADAPTOR to the
DC socket on the back of the cabinet, the TV set will be in stand by mode, the power
indicator is red.
2. Press the STAND BY ( ) button on the front panel or the Remote Control Unit, then
the power indicator is green, and the channel position number is displayed in the upper
right comer of the screen for 15 seconds.
3. Press the STANDBY ( ) button again, the set will go into STANDBY mode, the
indicator is red.
DC OUT
POWER INDICATOR
AC IN
3
.
.
.
.