Filter
Top Products
12
TV
VCR
VOLUME
AV
INPUT SELECT
VCR/TV
RESET
OSD/DISPLAY
PICTURE MODE
REC
TIMER
Á
NAVI
PROG/CHECK SPEED
ON
r
s
OFF
r
s
DATE
r
r
s
W
W
X
s
X
W
X
SEARCH
CANCEL
INDEX
OK
AUDIO
∫
1
3
4
2 1
56
9¥:
Í
Í
;/D
MENU
1 2 3 4
21
RF
OUT
IN
N
(AV1) OUT
VIDEO
AUDIO
3
1
AUTO CHANNEL SET
PROCEEDING
END : MENU
2
Tuning the TV to your VCR
The VCR supplies a signal to the TV via the RF
coaxial cable on channel US3 or 4.
It is possible to view the video picture on your
TV in the same way that you watch TV
broadcasts.
If you have connected the VCR to the TV
through the video and audio input sockets, then
you do not need to follow the procedure below.
When the VCR is turned on after unpacking
and connecting the antenna cable and the
AC power cord, Plug in Auto Tuning starts
automatically.
The VCR is fitted with its own tuner (just like a
normal TV) and can be preset to receive up to
181 TV broadcast stations.
Plug in Auto Tuning
Auto Tuning searches for TV stations from VHF
minimum to UHF maximum and memorizes
every tuned program position.
Notes:
–If the VCR is turned on with the antenna not
connected, all channels are skipped.
–When Auto Tuning is canceled halfway, Auto
Tuning is not executed even if the VCR is
turned off and then turned on again. In this
case, see page 13 “To Restart Plug in Auto
Tuning”.
1 Press [POWER Í/I (VCR Í)] to turn on the
TV and VCR after connecting the antenna
cable and the AC power cord, Auto Tuning
starts.
Channel being
searched
–Auto Tuning will stop halfway by turning
the VCR off, pressing [MENU], playback
or a power failure during Auto Tuning.
–When there are 5 more CATV channels,
the antenna system CATV is automatically
selected; when there are 4 or fewer CATV
channels, the TV is selected. If a change is
required, conduct the resetting procedure
described in step 4 on page 14.
2 Press [VCR/TV] to select the VCR mode.