Filter
Top Products
32
Program 2
To Check the Recorded
Programming Data
(Time Stamp Function)
When playback starts after searching with Jet
Navigator function or index search function,
recorded programming data (called Time
Stamp) appears on the TV screen for approx.
5 seconds.
Preparations
–Display the VCR picture on the TV.
–Be sure to set [OSD] to [ON]. (See page 18.)
–Press [VCR/TV] to select the VCR mode.Program 1 Program 3
Erased
New program
Within 10 minutes in the EP mode
Program 1 Program 2 Program 3
Erased
New program
Within 10 minutes in the EP mode
Program 1 Program 2 Program 3
Not erased
New program
10 minutes or more in the EP mode
To Demonstrate the Jet
Navigator Function
Keep [NAVI] pressed for more than 5 seconds
without inserting a cassette tape.
When Recording Over the Same Location
on a Tape:
–The originally recorded program is deleted
from the list.
–Program contents starting near the start and
end of the newly recorded program (within
10 minutes before the start and after the end
of the newly recorded program in the EP
mode) are also erased.
(Although old program contents are also
similarly erased in the case of ordinary
recording, the newly recorded program is not
registered in the list.)
CH 2
10/27. TH
ON 20:02
Note:
–Time Stamp does not appear if the beginning
of the Jet Navigator data are not recorded
10 minutes before and after the current tape
position in the EP mode even when index
signals are recorded.