Filter
Top Products
- 19 -
Press the Power Button on the Remote Control to select the Serviceman Adjustment
For Adjustments:
Geometry Adjustments
Default
Level
D00 H POSITION 13
D01 V SIZE 37
D02 V S CORRECTION 5
D03 V LIN CORRECTION 8
D04 E/W TRAPEZIUM 9
D05 V AGC 1
D06 V POSITION 1
D07 V CENTERING 65
D08 V CENTERING DAC SW 0
D09 V-BLK START 12
D0A V-BLK STOP 14
D0B EW CORNER 6
D0C EW PARABOLA 11
D0D H WIDTH 20
D0E OSD POSITION 90
MTS Adjustment
Default
Level
M00 INPUT LEVEL 33
M01 LOW-LEVEL SEPARATION 6
M02 HIGH-LEVEL SEPARATION 25
1.Press Channel Up/Down on the
Remote Control to select one of
the available Service Adjustments
(a in Fig. 20).
Note: Write Down the original
value set (b in
Fig. 20
) for
each address before
modifying anything. It is
easy to erroneously adjust
the wrong item.
2.Press Volume Up/Down on the
Remote Control to adjust the
level of the selected Service
Adjustment (b in Fig. 20).
IMPORTANT NOTE:
Always Exit the Serviceman
Mode Following Adjustments.
Note: Some adjustment modes may not be
available in some formats.
CH
CH
CH
PW
To P Items.
PW
CH