Filter
Top Products
23
Press the MENU-UP button or MENU-DOWN
button to move the cursor to NO, and press
the SET button.
The menu protection function is now released.
3
Set the LOCAL/MENU/REMOTE switch to the
LOCAL or REMOTE position.
The unit is now set to the menu protection mode.
When the LOCAL/MENU/REMOTE switch is set
to the MENU position, the VTR is not set to the
menu setting mode, and “MENU PROTECTED”
appears on the video monitor screen.
<Notes>
If, while the menu protection mode is being set,
the LOCAL/MENU/REMOTE switch is set to the
MENU position while the COUNTER button on
the front panel is pressed, the unit is set to the
menu setting mode, and regular menu settings
can be performed.
Perform steps 2 through 7 of “How to perform
settings using the on-screen menu.”
5
Setup (Initial Settings)
How to release the menu
protection
Set the LOCAL/MENU/REMOTE switch to the
MENU position while pressing the COUNTER
button on the front panel.
The unit is set to the menu setting mode, and the
menu screen is displayed on the video monitor.
1
2
MENU PROTECT OK?
2 NO
YES
Perform steps 2 and 3 of “How to protect the
menus.”
The screen for checking the menu protection
function is displayed on the video monitor.
How to display the DIAG menu
Set the LOCAL/MENU/REMOTE switch to the
MENU position while pressing the EJECT
button.
The unit is set to the DIAG display mode, and the
hours meter and deck’s serial number are
displayed on the video monitor.
1
Items with “r” can be reset when servicing is
performed.
DIAG–MENU HOURS METER
Ser
222222222
H00 OPERATION 00000H
H01 DRUM RUN 00000H
H02 TAPE RUN 00000H
H03 THREADING 00000T
H11 DRUM RUN r 00000H
H12 TAPE RUN r 00000H
H13 THREADING r 00000T
END
While the hours meter is displayed, press the
MENU-UP button or MENU-DOWN button
while pressing the PAGE button.
The software version is displayed on the video
monitor.
2
The hour meter display is restored by pressing
the MENU-UP button or MENU-DOWN button
again while pressing the PAGE button.
DIAG–MENU VERSION
<NTSC>
FRONT 1.22-22
IF 1.22-22-2.22
AV-SYSCON 1.22-22-2.22
SERVO 1.22-22-2.22
END
Set the LOCAL/MENU/REMOTE switch to the
LOCAL or REMOTE position.
Operation now returns to the regular mode.
3
This unit comes with a function for displaying the
“HOURS METER,” software “VERSION” and the
deck’s serial number on the video monitor.