Filter
Top Products
15
Setting Up
Í
DIRECT REC
REPEAT
VOLUME
SEARCH
PICTURE MODE
REC
VCR
DATE
++
–
+
–
ON OFF
TV
AV
+
–
MENU
OK
NAVI
INDEX
123
78
0
9
4
5
6
1 2 3 4
POWER
INPUT SELECT
JET REW
100
–
2
§
CH
Setting the Remote Controller for
Operation of your TV
You can operate the TVs of the manufacturers
listed below with the remote controller after
setting it.
§ Set VCR/TV switch to TV for using POWER
Í, the I and J buttons and the numeric
buttons.
01 Panasonic/National QUASAR
02 Panasonic/National QUASAR
03 MAGNAVOX SYLVANIA PHILIPS (RC-5)
04 ZENITH
05 THOMSON RCA GE
06 SHARP
07 SHARP
08 SONY
09 TOSHIBA
10 SANYO FISHER
11 JVC
12 HITACHI PHILCO
13 MITSUBISHI
14 SAMSUNG
15 GOLDSTAR/LG
16 GOLDSTAR/LG
17 GOLDSTAR/LG
18 SAMSUNG
Preparation
≥Install the batteries in the remote controller.
Operations
1 Find the manufacturer number of your TV
while referring to the table.
2 While holding down POWER Í, use the
numeric buttons to enter the manufacturer
number. This completes the settings for the
TV manufacturer.
≥Be sure to enter the number in two digits.
Example: 1>01
3 To confirm that the correct settings were
made, check whether the TV can be
operated properly.
≥When a manufacturer has multiple
numbers in the table, try entering other
numbers if the TV operations cannot be
performed properly, and then select the
optimal number.
Notes:
≥If you are using a Panasonic TV, this setting
has already been made, and so you do not
need to perform the above setting procedure.
However, this remote controller may not work
with some Panasonic TVs.
≥Some TV models cannot be operated using
this remote controller (including all TVs non-
remote compatible).