Filter
Top Products
Getting started
RQT6270
6
Connection to a television
Although the audio on most DVDs is designed to be played through six speakers and this unit’s factory settings assume this setup, the following
describes the basic connections that allow you to enjoy sound through your television’s speakers. To get the full benefit from the powerful
5.1-channel audio found on DVDs, you should connect an amplifier and six speakers. Descriptions of this kind of connection start on page 22.
Before connection
≥Disconnect the AC power supply cord.
≥Refer to the television’s operating instructions.
CENTER
AUDIO OUT
SUB-
WOOFER
R
R
FRONT
R
SURROUND
VIDEO
OUT
S VIDEO
OUT
COMPONENT
VIDEO OUT
Y
P
B
P
R
SURROUND
L
FRONT
L
L
2ch5.1ch
AC IN
AUDIO
IN
L
R
VIDEO
IN
P
B
P
R
Y
To household AC outlet
(AC 120 V, 60 Hz)
Television
AC power supply cord
(included)
Back of the unit
[A] S VIDEO OUT terminal
[B] COMPONENT VIDEO OUT terminal
S video cable (not included)
TV’s S video
input
terminal
Video cable (not included)
TV’s component video
input terminals
Y terminal
PB terminal
PR terminal
Audio/video cable (included)
Yellow (VIDEO)
White (L)
Red (R)
≥Connection to AUDIO IN also necessary (see left)
[A] S VIDEO OUT terminal
The S-video terminal achieves a more vivid picture than the VIDEO
OUT terminal by separating the chrominance (C) and luminance (Y)
signals. (Actual results depend on the television.)
[B] COMPONENT VIDEO OUT terminal
These terminals provide a purer picture than the S VIDEO OUT
terminal. Connection using these terminals outputs the color differ-
ence signals (PB/PR) and luminance signal (Y) separately in order to
achieve high fidelity in reproducing colors.
≥The description of the component video input terminals depends on
the television or monitor (e.g. Y/PB/PR, Y/B-Y/R-Y, Y/CB/CR).
≥Connect to terminals of the same color.
≥After making this connection, change the black level for a better
picture (➡ page 19, Video—Black Level Control).
Conserving power
This unit consumes a small amount of power, even when it is turned
off (approx. 2 W). To save power when the unit is not to be used for a
long time, unplug it from the household AC outlet.
Connect Your Unit Directly To Your
Television.
Do not connect the unit through your video cassette recorder
when setting up your home entertainment system. The picture
may not be displayed correctly due to the copy guard.