Filter
Top Products
27
Note:
There is little change when Picture is increased with a bright picture or reduced with a dark picture.
Picture Adjustments
Item
Contrast
Brightness
Colour
Tint
(NTSC only)
Sharpness
Effect Adjustments
Less More
Darker Brighter
Reddish Greenish
Selects the proper brightness and
density for the room.
Adjusts for easier viewing of dark pictures
such as night scenes and black hair.
Adjusts slightly to a lighter colour.
Adjust for nice skin colour.
Displays a sharp image.
Notes:
(1)
“Colour” , “Tint” and “Sharpness”
settings cannot be adjusted for
“RGB” and “PC” input signal
modes.
(2) You can change the level of each
function (Contrast, Brightness,
Colour, Tint, Sharpness) for each
Picture menu.
(3) The setting details for normal,
dynamic and cinema respectively
are memorized separately for
each input mode (AV, Component,
RGB).
(4) The “Tint” setting can be adjusted
for NTSC signal only.
Less More
Less More
Helpful Hint (
/
Normalise
Normalisation)
N
Advanced Settings
Item
Black
extension
W/B High R
W/B High B
W/B Low R
W/B Low B
Gamma
Effect
Less More
Less More
Less More
Less More
Details
Adjusts the dark shades of the image in gradiation.
Adjusts the white balance for light red areas.
Adjusts the white balance for light blue areas.
Adjusts the white balance for dark red areas.
Adjusts the white balance for dark blue areas.
2.0
2.2
2.5
Notes:
(1) Carry out “W/B” adjustment as follows.
A Adjust the white balance of the bright sections using the “W/B High R” and “W/B High B” settings.
B Adjust the white balance of the dark sections using the “W/B Low R” and “W/B Low B” settings.
C Repeat steps A and B to adjust.
Steps A and B affect each other’s settings, so repeat each step in turn to make the adjustment.
(2) The adjustment values are memorized separately for each input mode (AV, Component, RGB and PC).
(3) The adjustment range values should be used as an adjustment reference.
Less More
Down Up
On the remote control unit, while the “Advanced settings” menu is displayed, if either the N button is pressed at any
time or the
(Access button) is pressed during “Normalise”, then all adjustment values are returned to the factory
settings.