Filter
Top Products
ENGLISH-17
Preparation
%TEMP indicator (page 52)
This indicator illuminates if an abnormally high temperature is detected inside
the projector or around it. If the temperature rises above a certain level, the
power supply will be turned off automatically and the indicator will flash.
&Illumination sensor (page 39)
This sensor detects the luminance when the “DAYLIGHTVIEW” function is
operating. Do not cover the projector and do not place any object on the
projector when using it.
'POWER button (pages 24, 26 and 27)
This button is used to turn the power on and off. This button on the
projector illuminates red when the projector is in standby mode, and it
illuminates green when a picture starts to be projected.
(INPUT buttons (page 25)
These buttons are used to switch the input signals from the connected
equipment.
)AUTO SETUP button (pages 25 and 28)
If this button is pressed while a picture is being projected, the projection
settings will be adjusted automatically in accordance with the signal being
input. In addition, the angle of tilt of the projector will be automatically
detected and adjusted in order to correct any keystone distortion.
*MENU button (pages 32 and 34)
This button is used to display the “MAIN MENU”. When a menu screen is
being displayed, this button can be used to return to a previous screen or
to clear the screen.
+Arrow (
FFGGII
and
HH
) buttons (page 34)
These buttons are used to select and adjust items in the on-screen menus.
,ENTER button (page 34)
This button is used to accept and to activate items selected in the on-screen
menus.
-FREEZE button (page 29)
This button is used to momentarily freeze projection so that a still picture is
displayed.
.SHUTTER button (page 29)
This button is used to momentarily turn off the picture and sound.
/VOLUME +/- buttons (page 30)
These buttons are used to adjust the volume of the sound output from the
projector’s built-in speaker. Refer to page 33 for details on how to adjust
the volume without using the remote control unit.
0STD (standard) button (page 35)
This button is used to reset the projector adjustment values to the factory
default settings.
1INDEX WINDOW button (page 31)
This button can be used to split the image projection area into a still picture
and a moving picture. When NETWORK is selected, the screen display will
be switched between four window style, index style, and 16 Index style.
(PT-LB20NTU only. Refer to the accessory CD-ROM for details.)
2D.ZOOM +/- buttons (page 30)
These buttons are used to enlarge the projected image.