Filter
Top Products
ENGLISH-25
Basic operation
Press the input select button to select the
input signal.
Follow the procedure below when you set the projector up first, and when
you change the setup place.
Press the AUTO SETUP button to
initiate automatic positioning.
BThe tilt of the projector and the input
signal will be detected and keystone
distortion and the position of the image
will be corrected.
(Refer to page 28 for details.)
Adjusting the size
BTurn the zoom ring to adjust the size of the projected image.
Adjusting the focus
BTurn the focus ring to adjust the focus of the projected image.
AUTO SETUP
&
'
)
*
(
Adjusting the angle
BWhile pressing the adjuster buttons,
adjust the forward/back angle of tilt
of the projector. Adjust so that the
projected image is placed at the
center of the screen.
BA picture will be projected in accordance with the selected input
signal.
BWhen a YPBPR signal is being input, “YPBPR” will be displayed
instead of “RGB”.
B“NETWORK” is for PT-LB20NTU only.