Filter
Top Products
38 –
ENGLISH
Projection (continued)
Powering up the projector
1
Connect the supplied power
cable. (120 V/240 V, 50 Hz/60 Hz)
2
Press the “ | ” marked side of the
MAIN POWER switch to turn on
the power.
The power indicator lamp on the projector will •
flash in red. After a short period, the indicator
will illuminate and the projector will enter
standby mode.
3
Press POWER ON “ | ”.
The power indicator lamp illuminates in green •
and soon the image is projected on the screen.
Note
If the projector is powered up at about 0 C, a •
warm-up period of approximately 5 minutes may
be necessary to start projection. The temperature
monitor (TEMP) lamp lights up during the warm-up
period. When the warm-up is completed, the
temperature monitor (TEMP) lamp turns off and the
image is projected on the screen.
If the temperature of the operating environment is •
low and warm-up takes more than 5 minutes, the
projector will judge that a problem has occurred
and the power will be turned off automatically. If
this happens, increase the temperature around the
projector so that it is 0 C or higher, and then turn
on the MAIN POWER switch and the POWER ON
“ | ” switch once more.
Making adjustment and
selection
4
Roughly adjust the focus of the
lens. (p. 40)
5
Select and set the projection
scheme. (p. 78)
6
Select the input signal by
pressing the input selector
button RGB1, RGB2, DVI-D,
VIDEO, S-VIDEO and AUX. (p. 48)
The AUX button is disabled when an optional •
input module is not connected.
7
Adjust the tilt of the main unit in
front and rear or right and left.
(p. 20)
8
Adjust the H & V Lens shift as
required. (p. 40)
9
Press AUTO SETUP if the input
signal is RGB signal. (p. 49)
j
Zoom the lens so the image fills
the screen. (p. 40)
k
Adjust the focus. (p. 40)
l
Readjust the zoom so that the
image size fits in the screen.
(p. 40)
12 7
9
63 5
5
6
8
j
3
9
4
,
8
-
l
4
,
k