Filter
Top Products
62 –
ENGLISH
Adjusting the position (continued)
Adjusting the zoom ratio
This adjusts the size of the projected pictures.
Press ▲▼ to select “ZOOM”.1.
ASPECT
ZOOM
CLOCK PHASE
DEFAULT
0
Press ENTER.2.
The “ZOOM” screen will be displayed.•
ZOOM
MODE
INTERLOCKED
V
H
HV
INTERNAL
OFF
100%
100%
100%
Press ▲▼ to select “MODE”.3.
Press ◄► to switch “MODE”.4.
The setting will change as follows each time •
◄► is pressed.
INTERNAL FULL
INTERNAL:•
Enlarges the size of the pictures to within the
default aspect ratio.
FULL:•
Enlarges the size of the pictures using the whole of
the display area selected with “SCREEN FORMAT”.
Press ▲▼ to select 5.
“INTERLOCKED”.
ZOOM
MODE
INTERLOCKED
V
H
HV
INTERNAL
OFF
100%
100%
100%
Press ◄► to switch 6.
“INTERLOCKED”.
The setting will change as follows each time •
◄► is pressed.
OFF ON
OFF :•
The “V” and “H” settings are used as the vertical
and horizontal zoom ratios respectively.
ON :•
The zoom ratio is set to the “HV” setting. This
allows the pictures to be zoomed at equal vertical
and horizontal ratios.
Note
When “ASPECT” is set to “THROUGH”, “ZOOM” •
will not appear.
When other than “DEFAULT” is selected for •
“ASPECT”, the “MODE” selection setting will not
appear.
Clock phase adjustment
Clock phase adjustment achieves the best image
when the screen flickers or halos are observed
around contours.
Press ▲▼ to select “CLOCK 1.
PHASE”.
ZOOM
CLOCK PHASE
GEOMETORY
0
OFF
Press ◄► or ENTER.2.
The “CLOCK PHASE” individual adjustment •
screen will be displayed.
CLOCK PHASE
ADJUST
0
Press ◄► to adjust the level.3.
The value changes from 0 to 31. Adjust so that •
the amount of interference is at a minimum.
Note
No optimal value may be obtained if the output •
of the PC to which the signal input is applied is
unstable.
No optimal value may be obtained if the total •
number of dots is not correct.
The clock phase can be adjusted only when RGB •
signal input is applied with RGB1 and RGB2 IN.
Adjusting the geometry
Square video can be projected onto a special shaped
screen using unique image processing technology.
Press ▲▼ to select 1.
“GEOMETRY”.
ZOOM
CLOCK PHASE
GEOMETRY
0
OFF
Press ◄► to switch 2.
“GEOMETRY”.
The setting will change as follows each time •
◄► is pressed.
OFF
PC
KEYSTONE
CURVED