Filter
Top Products
VQT4J81
32
32
Past recording function (PRE-RECORD)
To set the past recording to ON:
• Press [STOP g/RETURN] to stop the unit.
1
Press [MENU].
2
Press +, – to select “MIC REC MENU”
and press [q OK] to enter.
3
Press +, – to select
“PRE-RECORD” and
press [q OK] to enter.
4
Press +, – to select “ON”
and press [q OK] to enter.
(The factory setting is “OFF”.)
To exit the setting screen, press [F2 (CLOSE)].
To record using the past recording
function:
When recording mode is PCM, the past recording
function does not operate.
• Set the recording mode to MP3.
(➜ page
25)
• Press [STOP g/RETURN] to stop the unit.
If you start recording from the standby state of the past recording function, recording can be started
with the audio approx. 3 seconds before the recording operation.
1
Press and hold [REC *] for 1 second or more.
The
unit enters the past
recording standby mode
.
Changes to 1 sec, 2 sec, 3
sec and stops at 3 sec. The
microphone audio data approx.
3 seconds before recording are
always updated and the unit is
on standby.
2
Press [REC *].
The recording indicator lights, and recording is started
continuing directly after the preserved audio data.
To stop: Press [STOP g/RETURN].
*
The sound that occurs when the recording button is pressed
is also recorded. (When the built-in microphone is used, etc.)
*
When the recording level adjustment
(➜ page
27)
is set
to MANUAL, the unit enters the past recording standby
and recording standby at the same time.
* When the unit enters the standby state again after the
microphone position is switched (➜ page 14), the past
recording standby screen is cancelled on the menu or
the stop operation is performed, audio data is freshly-
stored from that point.
* The past recording function operates when recording
actually star
ts. It does not operate when recording is
paused.
*
If the recording remaining time is less than 10 seconds,
the past recording function does not operate.