Filter
Top Products
REFERENCE
45
Back Panel
IN FROM ANT Use to connect an off-air antenna or cable TV signal to
the DSS
®
system.
OUT TO TV Use to connect the satellite receiver to your TV. However,
if your TV has audio/video jacks, you should use those jacks to get better
picture and sound quality.
CH3/CH4 SWITCH If a coaxial cable is used to connect the satellite
receiver to your TV, you must set the CH3/CH4 SWITCH. For example, to
see the DSS
®
signal on TV channel 3, set the switch to 3.
S-VIDEO Provides the best picture quality. If your TV has S-VIDEO
capability, use this jack along with the audio/video input jacks to connect
the satellite receiver to your TV.
VIDEO Provides better picture quality than the OUT TO TV jack. If your
TV has audio/video capability, use this jack to connect the satellite receiver
to your TV. You must also connect the AUDIO jacks.
AUDIO (R and L) Provide better sound quality than the OUT TO TV
jack. If your TV has audio/video capability, use these jacks to connect the
satellite receiver to your TV. You must also connect the VIDEO jack.
WIDE BAND and LOW SPEED DATA PORTS These ports allow you
to connect the DSS
®
system to future services and accessories as they
become available. A shielded cable and additional hardware may be
required.
SATELLITE IN Use to connect the satellite receiver to the satellite dish.
VCR CONTROL Allows the receiver and VCR to communicat with via
the VCR controller for timer recordings.
REMOTE IN Use in conjunction with remote control signal senders to
control the receiver from another room.
PHONE JACK Use to connect a phone line to the satellite receiver.
The DSS
®
system uses a phone line connection to periodically call out to
program providers.
OUT
TO
TV
IN
FROM
ANT
S-VIDEO VIDEO R LAUDIO WIDE BAND DATA
VCR CONTROL
REMOTE IN
SATELLITE IN
LOW SPEED DATA
PHONE JACK
CH 3
CH 4