18
Initial selections
1/2
PC
OFF
STANDBY SAVE
OFF
POWER MANAGEMENT
OFF
AUTO POWER OFF
OFF
OSD LANGUAGE ENGLISH
(
US
)
COMPONENT/RGB-IN SELECT
RGB
INPUT LABEL
SIGNAL
POWER SAVE
SET UP
INPUT MENU ENTER/+/VOL
-
/
INPUTMENU ENTER/
+
/VOL
-
/
TH-42PS9
.......(Japanese)
.......(Chinese)
Italiano
Français
Deutsch
English(UK)
Español
ENGLISH(US)
.......(Russian)
Русский
Selecting the On-Screen Menu Language
Selecting the input signal
Press to display the SET UP menu.
Press to select OSD LANGUAGE.
Press to select your preferred language.
Selectable languages
Select the input signals to be connected by installing the optional Terminal Boards.
Press to select the input signal to be played back from the
equipment which has been connected to the Plasma Display.
Notes:
• Selecting is also possible by pressing the INPUT button on the unit.
• Input terminal will not be selected if the terminal board is not installed into the SLOT.
• Select to match the signals from the source connected to the component/RGB input
terminals. (see page 36)
• In 2 screen display, the same input mode cannot be selected for the main picture and
sub picture.
INPUT1
INPUT2A
PCINPUT3
INPUT2B
SLOT2 is for dual input so that you can select INPUT2A or
INPUT2B for INPUT2.
INPUT2A : VIDEO signal terminal in SLOT2
INPUT2B : S-VIDEO signal terminal in SLOT2
Input signals will change as follows:
• TH-37PH10UK
• TH-42PH10UK, TH-50PH10UK, TH-58PH10UK
INPUT1A INPUT2 PCINPUT1B
SLOT1 is for dual input so that you can select INPUT1A or
INPUT1B for INPUT1.
INPUT1A : VIDEO signal terminal in SLOT1
INPUT1B : S-VIDEO signal terminal in SLOT1