SYNC
SIGNAL
[
RGB
]
3 : 2 PULLDOWN
XGA MODE
AUTO
OFF
AUTO
SYNC
AUTO
SYNC
ON G
SYNC
VBS
H-FREQ.
V-FREQ.
kHz
Hz
63.98
60.02
SIGNAL FORMAT 1280×1024/60
H-FREQ.
V-FREQ.
kHz
Hz
63.98
60.02
DOT CLOCK FREQ.
MHz108.0
SIGNAL FORMAT 1280×1024/60
3 : 2 PULLDOWN
SIGNAL
OFF
SDI THROUGH
OFF
[
Digital
]
NOISE REDUCTION
OFF
REFRESH RATE
100 Hz
54
SET UP for Input Signals
Select SIGNAL from the “SET UP” menu during RGB input signal.
SYNC
Setting RGB sync signal
Confi rm that the input is set to RGB INPUT (this setting is valid only for RGB INPUT signal).
AUTO: The H and V sync or synchronized signal are automatically selected.
If both input, it is selected the H and V sync.
ON G: Uses a synchronized signal on the Video G signal, which is input from
the G connector.
VBS: Uses a synchronized signal of Composite Sync input, which is input
from the HD connector.
Displays the frequency and the type of the current input signal.
This display is valid only for COMPONENT/RGB/PC and Digital input signal.
Display range:
Horizontal 15 - 110 kHz
Vertical 48 - 120 Hz
The dot clock frequency is displayed during digital signal input.
Input signal display
Press to select the “SYNC”.
Press to adjust.
Press to select the “SDI THROUGH”.
Press to select “ON” or “OFF”.
ON: Enables active through.
OFF: Disables active through.
Set the active through function of the Dual Link HD-SDI Terminal Board (TY-FB11DHD).
Note:
Settings can only be performed for this menu when a slot mounted with a Dual Link HD-SDI Terminal Board (TY-FB11DHD)
is selected.
SDI THROUGH