Filter
Top Products
AUDIO OUT
R L
1
2
SERIAL PC IN
AUDIO
AUDIO OUT
R L
SLOT1 SLOT3
P
R
/C
R
/R P
B
/C
B
/B
Y/G
AUDIO
R L
COMPONENT/RGB IN
SLOT2
9
Connections
Note:
Two fi xing bands are supplied with this unit. In case of securing cables at three positions, please purchase it separately.
– How to Unfasten the AC cord
– Cable fi xing bands
Secure any excess cables with bands as required.
Pass the attached cable
fi xing band through the
clip as shown in the
fi gure.
To secure cables connected to Terminals, wrap the cable fi xing band around them then
pass the pointed end through the locking block, as shown in the fi gure.
While ensuring there is suffi cient slack in cables to minimize stress (especially
in the power cord), fi rmly bind all cables with the supplied fi xing band.
To tighten:
Loosen the fi xing band securing the AC cord.
To loosen:
To loosen:
Pull
Pull
Pull
Push the catch
Push the catch
Note: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.
AUDIO OUT Terminals connection
Stereophonic sound code
audio equipment
line-in
From SERIAL
Terminal on
Computer
(see page 11)
From EXTERNAL
monitor terminal
on Computer
(see page 10)
Dual HDMI Terminals
(equivalent of Dual
HDMI Terminal Board
(TY-FB10HMD))
(see page 12)
Optional Terminal
Board Insert Slot
(covered)
COMPONENT/RGB IN and
Audio IN Terminals (equivalent
of BNC Component Video
Terminal Board (TY-42TM6A))
(see page 12)
From input
on audio
amplifi er
(see page 9)