Filter
Top Products
Operating Instruction Book
TU-HDT105A
Mode B (HD, RGB)
You have selected HD(RGB) format
at the rear panel switch.
Press OK to continue.
The switch on the rear of the digital receiver
must be in position B, and the AV
connections must be taken from the RGB
HD15 socket. The digital receiver display
will show “Hd r”. Press OK to confirm the
selection, or switch to another mode.
Proceed to INSTALLATION.
Mode C (SD, CVBS)
The switch on the rear of the digital receiver
must be in position C, and the AV
connections must be taken from the CVBS
TV RCA socket. The digital receiver display
will show “Sdtv”. Press OK to confirm the
selection, or switch to another mode.
Proceed to INSTALLATION.
You have selected SD(TV/CVBS)
format at the rear panel switch.
Press OK to continue.
Installation
The on-screen display will ask which type of display
device is being used. You will have a choice of
either Plasma, LCD (Flat panel displays) or CRT
(eg Standard television).
Select from the choices using the remote control
keypad. The following screen will ask you to
confirm 576i / 576p (depending upon the current
mode). Follow the on-screen instructions to test HD576p, HD1152i, HD1080i and
HD720p formats.
Please select the display type:
1 Plasma Display
2 LCD TV
3 CRT TV
Note: Not all video formats are available in all modes. The following table describes
the available formats in each mode.
HD (YPbPr) HD (RGB) SD (CVBS)
LCD/Plasma CRT LCD/Plasma CRT LCD/Plasma CRT
576i X X X X
576p X X X X
1080i X X X X
1152i X X
720p X X
Table 1: Output format table
10