Filter
Top Products
71 (E)
CONTENTS
RS-232C interface
$ Commands relating to inquiries
<Notes>
O As for the return (completion) message, [ACK] is
first returned when data is received, and the
execution message is subsequently returned. It
is only the execution message which is listed in
this table.
O In the case of commands not listed in the table,
ER001 (invalid command) is returned after [ACK]
has been returned.
VTR
operation
Send command
CTL/TC DATA
REQUEST
[STX] QCD [ETX] 45 [STX] CD data [ETX]
This command is for inquiring about the counter
value.
data = f w gh mm ss ff
f=F
w=S
gh =
CTL mode:
g=SP (20h) : for a plus display
– (2Dh) : for a minus display
h=0 – 9 : hours
TC mode:
gh = 00 – 23 : hours
mm = 00 – 59 : minutes
ss = 00 – 59 : seconds
ff = 00 – 24 : frames
<Note>
CTL or TC is returned, whichever corresponds to
the front display mode.
Return (completion)
message
STATUS
REQUEST
[STX] QOP [ETX] 45 [STX] 222 [ETX]
This command is for inquiring about the VTR’s
operation mode.
222
=
OEJ : EJECT
OFF : FAST FORWARD
OPL : PLAY
ORC : REC
ORW : REWIND
OSP : STOP (including the STANDBY ON)
SRS : (IN/OUT) PREROLL
OBF : STANDBY OFF
OSF : SHTL FORWARD
OSR : SHTL REVERSE
OJG : JOG FORWARD/REVERSE
OSW : VAR FORWARD/REVERSE
EAE : AUTO EDIT
EON : EDIT ON (MANUAL EDIT)
EPV : PREVIEW
ERV : REVIEW
ID (VTR No.)
REQUEST
[STX] QID [ETX] 45 [STX] data [ETX]
This command is for inquiring about the VTR
used.
data = AJ-SD930E (AJ-SD930E)
or
AJ-SD955E (AJ-SD955E)