Filter
Top Products
13
POWER UP YOUR D 200
After your D 200 is connected to the rest of your home theater system you are ready for its
shake-down cruise. Select the TV’s Input for its Input jacks which you connected to the
D 200’s Video Out jacks.
- Press the D 200’s rear panel Master AC Power switch to its On position. You should now
notice a very faint red glow behind its Power button.
- Press the Power button on the front panel to turn the D 200 on.
- You can now press the LOAD button and insert a DVD into the exposed loading tray.
A few seconds after you press the PLAY button you should see and hear the opening
screens of the movie.
- Once you are confident that the D 200 is properly connected to the rest of your system you
may want to adjust some of the settings in the setup menu. The next section of this manual
is dedicated to the setup menu.
Note: If you don’t see/hear anything now, please recheck your connections and make sure your
TV is on. Check that the TV and surround controller (or AV receiver) selected inputs are the same
as the input jacks which are connected to the D 200.