Filter
Top Products
SmartNode 10100 Series Quick Start Guide 3
1.0 Before you Begin
In the box, you will find:
• One SmartNode 10100
• One set of mounting brackets with screws
• One DB-9 to RJ-45 adapter
• Three CAT5 Ethernet straight cables (male-male), three meters in length
• One warranty sheet
• One packing slip
• One SmartNode 10100 Series Quick Start Guide
• One SmartNode 10100 Important Notice sheet with unique information for your specific unit
To install the SN10100, you will need (not included):
• Two AC power cords
• 19” equipment rack
Note Two DC power cable are included with DC units.
Electrostatic Discharge (ESD) can damage equipment and impair electrical
circuitry. It occurs when electronic printed circuit cards are improperly
handled and can result in complete or intermittent failures. Do the follow-
ing to prevent ESD:
• Always follow ESD prevention procedures when removing and replac-
ing cards.
• Wear an ESD-preventive wrist strap, ensuring that it makes good skin
contact. Connect the clip to an unpainted surface of the chassis frame
to safely channel unwanted ESD voltages to ground.
• To properly guard against ESD damage and shocks, the wrist strap
and cord must operate effectively. If no wrist strap is available,
ground yourself by touching the metal part of the chassis.
CAUTION