Peerless Industries DS-VW760 TV Mount User Manual


  Open as PDF
of 14
 
E
F
G
solid concrete
cinder block
VIDEOWALL
MOUNTASSEMBLY
Installation to Solid Concrete or Cinder Block
• WheninstallingPeerlesswallmountsoncinderblock,verifythatyouhaveaminimumof1-3/8"(35mm)ofactual
concrete thickness in the hole to be used for the concrete anchors. Do not drill into mortar joints! Be sure to mount
inasolidpartoftheblock,generally1"(25mm)minimumfromthesideoftheblock.CinderblockmustmeetASTM
C-90specications.Itissuggestedthatastandardelectricdrillonslowsettingisusedtodrilltheholeinsteadofa
hammer drill to avoid breaking out the back of the hole when entering a void or cavity.
• Concretemustbe2000psidensityminimum.Lighterdensityconcretemaynotholdconcreteanchor.
• Makesurethatthewallwillsafelysupportfourtimesthecombinedloadoftheequipmentandallattachedhardware
and components.
WARNING
1
CUTAWAY VIEW
INCORRECT CORRECT
wall
plate
wall
plate
plaster/
dry wall
plaster/
dry wall
concrete
concrete
1
3
2
F
Drillholesandinsertanchors(F).
Placeplate(A)overanchors(E)andsecurewithscrews(F).
Tighten all fasteners.
A
F
E
concrete
surface
• Tightenscrewssothatwallplateisrmlyattached,
but do not overtighten.Overtighteningcandamage
screws, greatly reducing their holding power.
• Nevertighteninexcessof80in.•lb(9N.M.).
• Alwaysattachconcreteexpansionanchorsdirectly
to load-bearing concrete.
• Neverattachconcreteexpansionanchorsto
concrete covered with plaster, drywall, or other
nishingmaterial.Ifmountingtoconcretesurfaces
coveredwithanishingsurfaceisunavoidable,
thenishingsurfacemustbecounterboredas
shown below. Be sure concrete anchors do not
pull away from concrete when tightening screws. If
plaster/drywallisthickerthan5/8"(16mm),custom
fasteners must be supplied by installer
WARNING
Make sure that video wall mount assembly is level,
use it as a template to mark four mounting holes.
Drillfour1/4”(6mm)dia.holestoaminimumdepth
of2.5”(64mm).Insertanchors(F)inholesush
withwallasshown(right).Placevideowallmount
assembly over anchors and secure with four #14
x2.5”screws(E),andfenderwashers(G).Level,
then tighten all fasteners.
ISSUED: 04-23-10 SHEET #: 145-9010-2 04-27-10
7 of 14
 previous next