Filter
Top Products
7 of 9 ISSUED: 05-02-06 SHEET #: 202-9112-3 12-05-06
B
I
F
GENERIC
ADAPTER BRACKET
Insert and tape carriage bolt (I) into top hole of pitch-roll assembly (B). Attach tilt-roll assembly to adapter
bracket with four M10 socket screws (F). Tighten screws using 6 mm allen wrench (U).
Note: Adapter bracket (not UL evaluated, sold separately) will vary in size and style.
Note: Refer to adapter bracket instruction sheet for attachment of adapter bracket to plasma before proceeding
with step 5. If your adapter bracket has an aluminum race attached to it, remove before proceeding and discard race. It is
not used with this product.
• Do not overtighten screws! Overtightening may hinder
roll option.
CAUTION
4
5
Attach two pieces of vinyl trim (E) to wall plate (A). Next, attach one piece of vinyl trim to bottom of swivel box on arm
assembly (C).
4-1
Insert one finishing cap (L) into each unused hole of wall plate (A).
L
A
E
SWIVEL BOX
C