Filter
Top Products
Pelco Manual C1943M (9/99) 15
Figure 13. Configuring the COMMS file for VCRC-P Operation
10. Define operator access, save the GPI file, return to the MGR main menu screen and
press the tab to bring up the COMMS file (.SCP file). Refer to Figure 13.
11. In the COMMs file assign an equipment number “17” to the port on the CC1 that will be
used for communicating to the VCRC-P. Also, set communication settings for 9600
baud and even parity. Save the COMMs file, back out of the MGR program and trans-
fer all appropriate configuration files to disk and load these files onto the CC1 to which
your VCRC-P configuration is attached. You should now be ready to operate your VCR
via direct control from the CM9760-KBD.