Filter
Top Products
4 Pelco Manual C1943M (9/99)
MODELS
CM9760-VCRC-P VCR control unit capable of controlling 64 VCRs per unit. VCR
control is specific to Pelco TLR2096.
OPTIONS
CM9760-VCRC-PTX A 50-foot (15.2 m) VCR control cable with 1/8-inch jack on one
end (for connecting to VCR) and cord/shield (signal/ground) bare
wires at the opposite end for connection to input mating plugs lo-
cated on rear of VCRC-P.
PRE-INSTALLATION INFORMATION
FRONT VIEW
Figure 1 illustrates the front view of the unit. Power and data LEDs occupy opposite ends of
the front panel. The power LED on the left is green and the data LED on the right is red. All
other connectors, switches, inputs and outputs are on the rear of the unit except for two
DIP switches and a reset switch located behind the front panel cover plate.
The DIP switches can be easily accessed by removing the five flat-head Phillips screws that
hold the front panel in place as illustrated in Figure 2.
Figure 2. Front Panel Removal
Figure 1. Front View of CM9760-VCRC-P