Filter
Top Products
34 Pelco Manual C652M (7/99)
8.1.5 Series Recording
You can do series recording by connecting two or more TLR2168 VCRs together.
When the tape in the first VCR reaches the end during recording, the tape in the
second VCR automatically begins recording.
1. Set REC IN on the Rear Terminal menu to SERIES.
2. Set CALL OUT on the Rear Terminal menu to WRNG•TAPE END.
3. Set TAPE END on the First Time Set Up menu to REWIND.
Figure 19. Connecting VCRs in Series
8.1.6 One-Shot/Interval Recording
You can do one-shot recording or interval recording when the recording mode is
set to 0H.
1. Press the REC/PLAY MODE button to set the recording mode to 0H.
2. Set the number of fields in ONESHOT•FIELD in the Recording Set Up menu.
3. For one-shot recording, select SHOT in ONESHOT•INTERVAL.
For interval recording, choose the interval time from 10S (seconds) to 3M
(minutes) in ONESHOT•INTERVAL.
4. Press the REC button.
One-shot recording will be in standby mode. Interval recording begins with
the preset interval time.
5. To start one-shot recording, press the REC button or switch the REC IN termi-
nal on the rear panel to ground.
NOTES:
• Series recording may have a
short pause (up to five sec-
onds) when going from re-
corder A to recorder B. How-
ever, if you set CALL OUT in
the Rear Terminal menu to
WRNG•REMAIN, this delay is
eliminated.
• When set in the above configu-
ration and the second VCR
reaches the end of the tape,
the first VCR automatically
begins recording. Connect the
line marked by [*1] in Figure
19 only if you want the first
VCR to begin recording again.
If not, do not connect it.
• If a problem occurs (for ex-
ample, the motor malfunc-
tions during recording) in the
first VCR, the second VCR
automatically begins record-
ing.
• Series recording will not work
during timer recording.
• When recording in series, set
CALL OUT in the Rear Ter-
minal menu to a mode other
than WRNG.
SET RST
IN
REC GND ALM MODE CLK CALL
OUT
SET RST
IN
REC GND ALM MODE CLK CALL
OUT
[*1]