Pelco C652M (7/99) VCR User Manual


 
Pelco Manual C652M (7/99) 45
9.3.2 Skip Search
The VCR will fast forward or rewind until it finds an index signal. It then plays back
for about four seconds in 2H or 6H mode. It repeats this process until reaching the
end or beginning of the tape.
1. Press the COUNTER MEMORY/SKIP/INDEX button to illuminate SKIP on the
fluorescent display.
2. Turn the SHUTTLE ring to the right or left.
3. Press the PLAY button when the desired location is found. Or, press the STOP
button to end the skip search.
The index signal may be hard to find in some recording conditions.
9.4 ADJUSTMENT DURING PLAYBACK
9.4.1 Tracking Adjustment
If noise appears in the picture during playback, fast playback, reverse playback, or
forward/reverse slow playback, adjust the TRACKING buttons (+ and -) for the best
picture.
Press the PAUSE/SHUTTLE HOLD button while turning and holding the SHUTTLE
ring to adjust the tracking in fast playback, reverse playback, or forward/reverse
slow playback.
To return tracking to its initial setting, press the TRACKING buttons at the same
time during playback, reverse playback, or forward/reverse slow playback,
Figure 29. Skip Searching
NOTES:
Noise bars may appear when in
reverse playback or reverse slow
mode.
Noise bars will move continuously
through the picture when pressing
and holding a TRACKING button
(except in L24H playback mode).
Noise bars will move through the
picture each time a TRACKING
button is pressed (in L24H playback
mode).
Noise may appear when a tape re-
corded in 2H mode is played back
in L24H mode, despite adjustment
with the TRACKING buttons.
Figure 30. Tracking Adjustment
ALARM
RECORDING
ALARM
RECORDING
Present position
Index
Fast forwardFast forward
Index
Approx. 4 sec.
playback
Approx. 4 sec.
playback
Fast forward
IF NOISE APPEARS
TRACKING
POSITION/
VERTICAL
ADJUST
TRACKING
POSITION/
VERTICAL
ADJUST