Filter
Top Products
4
æ Positioning your television set
Place your TV on a solid, stable surface, leaving a space of at least 5
cm around the appliance.
To avoid accidents, do not put anything on the set such as a cloth
or cover, a container full of liquid (vase) or a heat source (lamp).
The set must not be exposed to water.
 Connecting the aerials
The television set is equipped with 2 internal aerials; one for
receiving TV channels, and the other for receiving FM radio
stations.
• I n s e rt the TV aerial plug into theMs o c k et at the rear of the set.
• Insert the radio aerial plug into the FM ANT socket.
With the internal aerials,the reception may be poor under certain
conditions.You can improve it by repositioning the aerial. If the
reception remains unsatisfactory, an external aerial should be used.
ê Connecting the power supply
Insert the mains plug into the wall socket
(220-240 V / 50 Hz).
® Remote control
Insert the two R6-type batteries (supplied) making sure that they
are the right way round.
The batteries supplied with this appliance do not contain mercury or nicke l
c a d m i u m . Please do not discard your used batteries if you have access to
a recycling facility (if in doubt, consult your dealer). When the batteries are
r e p l a c e d , use the same type.
† Switching on
To switch on the set, press the on/off key.
A red indicator comes on and the screen lights up. Go straight to
the chapter Quick installation on the following page.
If the television remains in standby mode, press P on the
remote control.
The hands of the clock move through 360° when the set is
switched on for the first time.
The indicator flashes when you use the remote control.
Installing your television set