Filter
Top Products
Preparing the remote control for
operation
The remote control and its batteries are packed
separately in the original TV-Video Combi pack-
aging.You must install the batteries in the
remote control before use.
1.
1.Take the remote control and the enclosed
batteries (2 batteries).
2.
2.Open the remote control’s battery compart-
ment and place the batteries in it as shown in
the picture and close the battery compart-
ment.
The remote control is now ready to use. Its
range is approximately 7 metres.
Connecting the cable
1.
1.Insert the aerial
cable plug into
the AERIAL at
the back of the
TV-Video Combi.
2.
2.
Connect the
mains cable to
the wall socket.
3.
3.If the little red standby light (STANDBY ) at
the front panel of the set is not lit, please
switch on the set using the main power
switch.The power switch is located on the
left side panel of the set.
4.
4.Language setting picture will appear on the
screen.
You can find more details in chapter ‘Preparation
for use’.
Connecting additional devices
You can connect addi-
tional devices such as
decoders, satellite
receivers, camcorders,
etc. to the EXT1/AV1
socket.
The respective scart socket is usually marked
‘AV’ or ‘TV’ on the decoder or satellite receiver.
EN
Specifications
Voltage: 220-240V/50Hz
Power consumption (Standby): less than 5W
Rewind time: less than 260 seconds
(cassette E-180)
Number of video heads: 2
Recording/playback time:
3 hours (SP) (cassette E-180)
6 hours (LP) (cassette E-180)
Power consumption: 52W
Dimensions in cm (HxWxD): 40.1x37.9x38.0
Weight without packing in kg: 10.5
Power consumption: 65W
Dimensions in cm (HxWxD): 51.2x51.0x49.5
Weight without packing in kg: 20.6
Supplied accessories
• Operating instructions
• Remote control and 2 batteries
21PV385
14PV135 14PV235
1. Connecting the TV-Video Combi
4
I do not see a Language setting picture
• Check the cable connections.
Selection of the scart socket
•
To select the Scart socket, please enter 0,0,1,
with the keys on the remote control. AV1
appears on the screen.
Selection of the front A/V sockets
•
To select the front A/V sockets, please enter
0,0,2, with the keys on the remote control.
‘AV2’ appears on the screen.
0..9
0..9
PUSH MENU TO CONTINUE
T6460/550/552EZ(EN)_EST.qx3 04.1.28 4:15 PM Page 4