Philips 28PW6315/05 Flat Panel Television User Manual


 
16
& After switching off the television, connect the RF
transmitter to the connector located on the back of
the set.Then click the module to the back of the TV as
shown opposite.
é Dispose the 2 loudspeakers at the rear and on either
side of the listener. Connect the active to the passive
loudspeaker with the supplied cable,according to the
polarity (the + on the + and the - on the -). C o n n e c t
the active loudspeaker to the mains (220-240 V / 50 Hz)
with the mains cable.
At the bottom of the active loudspeaker, set the slide
channel to channel 1. Switch on the active speaker with
the power switch.The indicator at the front of the
active speaker lights up in red when the speaker is in
standby and in green when there is a sound
transmission. It turns back to red (standby) when the
tv is switched off or when the rear channel is not used
(in the case of STEREO, 3 STEREO and 3D
SURROUND modes).
You have now to proceed to the surround speaker
adjustments in the TV menus (see next page).
Installation of the wireless system Philips A D 9 0 2 W
This system include :
- a wireless RF transmitter to be clicked to the back of
the TV,
- an active loudspeaker, including the RF receiver,the
mains supply, a power switch,a connector clip and a
channel selector located on the underside,
- a passive loudspeaker to be connected to the active
loudspeaker,
- a speaker cable.
The television can be equiped in option with a wireless surround speaker system (re fe rence A D 9 0 2 W).
With this system,the DOLBY PRO LOGIC and HALL SURROUND modes are now availables (see p.9 ) .
For more info rmations about this system, contact your dealer.You can also connect active loudspeake rs (see p. 1 4 ) .
Wireless surround speaker system