Filter
Top Products
18
There is a wide range of audio and video equipment that can be connected to your TV.
The following connection diagrams show you how to connect them.
Note:
EXT.1 can handle CVBS and RGB, EXT. 2 CVBS and Y/C, EXT.3 CVBS and RGB. It is preferred to connect
peripherals with RGB output to
EXT.1 or EXT. 3 as RGB provides a better picture quality.
If your recorder is provided with the Easylink function, it should be connected to
EXT.2 to benefit from the EasyLink
functionality.
Recorder
(VCR-DVD
+RW)
Connect the aerial cables 1, 2 and,to obtain the optimum
picture quality,eurocable 3 as shown.
If your recorder does not have a euroconnector,the only possible
connection is via the aerial cable.You will therefore need to tune in
your recorder’s test signal and assign it programme number 0 or
store the test signal under a programme number between 90 and
99, see Manual installation,p. 6.
See the handbook of your recorder.
Decoder and Recorder
Connect a eurocable 4 to your decoder and to the special
euroconnector of your recorder. See also the recorder handbook.
See Decoder,p. 9 You can also connect your decoder directly to
EXT. 1 or 2 with a eurocable.
Other equipment (satellite receiver,decoder,DVD, games,etc.)
& Connect the aerial cables 1, 2 and 3 as shown (only if
your peripheral has TV aerial in-/output).
Connect your equipment with a eurocable 4 or 5 to one of
the euroconnectors
EXT.1, 2 or 3 to obtain a better picture
quality.
é Look for the test signal of your peripheral in the same way as
you do for a recorder.
“ Make a selection in the Setup, Source menu, p. 9.
Side connections
Camera or Camcorder
& Connect your camera or camcorder as shown.
é Connect to VIDEO 2 and AUDIO L 3 for mono
equipment. For stereo equipment also connect AUDIO R 3.
S-VHS quality with an S-VHS camcorder is obtained by
connecting the S-VHS cables with the S-video input 1 and
AUDIO inputs 3.
Do not connect cable 1 and 2 at the same time.This may cause
picture distortion !
Headphone
& Insert the plug into the headphone socket L as shown.
é Press ¬ on the remote control to switch off the internal
loudspeakers of the TV.
The headphone impedance must be between 8 and 4000 Ohm.
The headphone socket has a 3.5 mm jack.
In the Sound menu select
Headphone volume to adjust the
headphone volume.
CABLE
1
4
2
EXT.
2
3
CABLE
1
2
1
EXT.
2
4
5
3
AU
D
IO
VIDEO
S•VIDEO
1 2 3
Connect Peripheral Equipment
2195.1 gb 03-03-2003 09:57 Pagina 18