Filter
Top Products
19
To enhance the sound reproduction of your TV
you can connect two extra front loudspeakers via
an external amplifier.
Connect the audio cables to the audio input of
your amplifier and to
AUDIO L and R at the back
of your TV.The output level is controlled by the
volume control of your TV.
Note: Switch off the TV and your audio amplifier before
connecting them. Set the audio amplifier’s volume to
minimum.
AUDIO
Press the v key on the remote control repeatedly to select EXT1, EXT2, EXT3 or SIDE according
to where you connected your equipment at the back or the right side of your TV.
Remark : Most equipment (decoder, recorder) carries out the switching itself, when it is switched on.
To select connected equipment
Connect stereo amplifier and two extra front speakers
The recorder (VCR or DVD+RW) or DVD can
be operated with the remote control via the
Recorder or DVD menu on screen.
& Press the MENU key on the remote control.
é Select the Recorder or DVD menu with the
cursor up/down.
“ Press the cursor left/right,up/down to select
one of the recorder or DVD functions.
The ® key for recording can be operated in the TV
mode.
If your EasyLink recorder has the system standby
function, when you press the B key for 3 seconds,
both TV and the recorder are switched to standby.
Ò p ‡ π † ® Ï
Rwd Play Stop Play Ffw Rec Eject
Recorder
Ò p ‡ π † Ï
Prev. Play Stop Play Next Eject
DVD
See the separate supplied Cinema Link instruction manual.
Attention: the sound info on screen will not correspond with the actual sound reproduction.
Cinema Link surround receiver
Recorder or DVD with EasyLink
2195.1 gb 03-03-2003 09:57 Pagina 19