Filter
Top Products
15
Press the v key on the remote control repeatedly to select EXT1, EXT2 or SIDE according to
where you connected your equipment at the back or the right side of your TV.
Remark : Most equipment (decoder, recorder) carries out the switching itself, when it is switched on.
To select connected equipment
See the separate supplied Cinema Link instruction manual.
Attention: the sound info on screen will not correspond with the actual sound reproduction.
Cinema Link surround receiver
Recorder or DVD with EasyLink
The recorder (VCR or DVD+RW) or DVD can
be operated with the remote control via the
Recorder or DVD menu on screen.
& Press the MENU Ï key on the remote
control.
é Select the Recorder or DVD menu with the
cursor up/down.
“ Press the cursor left/right, up/down to select
one of the recorder or DVD functions.
The key ® for recording can be operated in the TV
mode.
If your EasyLink recorder has the system standby
function, when you press the B key for 3 seconds,
both TV and the recorder are switched to standby.
Ò p ‡ π † ® Ï
Rwd Play Stop Play Ffw Rec Eject
Recorder
Ò p ‡ π † Ï
Prev. Play Stop Play Next Eject
DVD
& Connect the audio cables to the audio input of
your amplifier and to
AUDIO L and R at the
back of your TV.
é The output level is controlled by the volume
control of the amplifier.
Note: Switch off the TV and your audio amplifier
before connecting them. Set the audio amplifier’s
volume to minimum.
AUDIO
Stereo amplifier and two extra FRONT speakers
2224.1 gb 11-02-2003 08:55 Pagina 15