Filter
Top Products
Display User Manual
3D Solutions
23 September 2008
©2008 Philips Electronics Nederland B.V. 17 of 26
4 Software installation
This chapter contains the prerequisites for the PC hardware and the operating system for the
software. First, check whether your PC complies with the requirements that are given in the next
sections. Then follow the installation instructions, where you will be guided step by step through the
software installation procedure.
4.1 Minimum PC requirements
The PC must comply with the following requirements:
o Pentium 4, ≥ 3 GHz or Dual core ≥ 1.7 GHz
o ≥ 512 MB internal memory for Windows XP, ≥ 1024 MB internal memory for Windows Vista
o 7200 rpm hard disk with 8 Mbyte cache (minimal sustained throughput 10 MB/s)
o DVD ROM player
o Graphics card:
o based on NVIDIA for example 7600 or 8600 chipsets,
o or based on NVIDIA Quadro for example FX1400 (windows XP only),
o or based on ATI for example X1650 (Windows XP only).
o Windows XP SP2 or Windows Vista (see above for restrictions concerning graphics cards)
4.2 Prepare PC
Make sure that the following software is installed on the PC before connecting the 3D Display to the
PC:
o Windows XP (upgraded to Service Pack 2) or Windows Vista
o NVIDIA Display driver or ATI Driver (Windows XP only)