Filter
Top Products
17
Start a TV demo
1
Press MENU.
2 Select [Features] > [Demo] .
The » [Demo] menu appears.
3 Press to select a demo.
• [Dig.CrystalClear]Digitally adjusts
picture quality to optimal contrast,
colour and sharpness.
• [Active Control]Automatically
adjusts the picture setting for optimal
picture quality continuously under
any signal conditions.
4 Press OK to start the demo.
5 Press MENU to exit.
Reset the TV to factory
settings
You can restore the default picture and sound
settings of your TV. Channel installation settings
remain the same.
1 Press MENU.
2 Select [Installation] > [Factory settings] .
3 Press to enter the [Factory settings]
menu.
» [Reset] is highlighted.
4 Press OK to reset to factory settings.
5 Press MENU to exit.
Access decoder channel
You can map channels provided through a
decoder or descrambler to your TV channel
selection. In this way, you can select these
channels by using the RC of your TV. The
decoder or a descrambler must be connected
to EXT1 or EXT2.
Set decoder channel
Map channels from a decoder or descrambler
1 Press MENU.
2 Select [Installation] > [Decoder] .
3 Press to enter [Decoder].
4 Press to enter [Channel].
5 Press to select channel number to
map to the decoder/descrambler channel.
6 Press OK.
7 Press to select and enter [Status].
8 Press to select the connector used by
the decoder/descrambler ([None], [EXT
1] or [EXT 2] .
9 Press OK.
10 Press MENU to exit.
Note
Select • [None] if you do not want to map to
the decoder/descrambler channel.
• [EXT 2] is available only in TVs of 26 inches
and larger.
English
EN