Filter
Top Products
3
Your television has a set of buttons located on the front of
the cabinet for use when the remote control is not needed or
unavailable.
1
Press the Power button to turn the TV on.
2
Press the VOLUME + (up) button to increase the sound
level or the VOLUME – (down) button to lower the sound
level. Or use the buttons to navigate right or left when the
on-screen menu is displayed.
3
Press the CHANNEL K (up) or L (down) button to select
TV channels. Or use the buttons to navigate up and down
when the on-screen menu is displayed.
4
To access the on-screen menu, press the MENU button. To
navigate the menu, use the VOLUME + (up)/– (down) and
CHANNEL K (up)/L (down) buttons to navigate the menu
as described in the previous steps.
5
To remove the menu, Press CHANNEL Down to select Exit.
Then press the MENU button,
V
O
L
U
M
E
C
H
A
N
N
E
L
I
N
TE
L
L
I
S
E
N
S
E
M
E
N
U
P
O
W
E
R
4
1
5
2
4
3
4
Picture Sound Features Channels
TV
Settings
Demo
Install
Exit
5
Using the TV Buttons
Using the Remote Control
To load the supplied batteries into the remote:
1
Remove the battery compartment door on the back of
the remote.
2
Place the batteries (2-AA) in the remote. Make sure the (+)
and (–) ends of the batteries line up correctly (the inside of
the case is marked).
3
Reattach the battery compartment door.
Be sure to point the remote at the Remote Sensor window on the
front of the television when using it to operate the television.
Installing the Batteries
3
2
1
Remote Control
(shown from the bottom)
When the batteries in your remote control run low, the remote
control will send a “Battery low” command to the TV. The TV
will then display a message on the screen reminding you to
replace the batteries as soon as possible.
H
ELPFUL HINT
Blue LED indicator
IMPORTANT! Initial TV Setup
When you turn on your TV for the first time it will prompt you to enter
some setup information about Language preference and Channel program-
ming. See page 6-7, “Using the Installation Features” in this Quick Use and
Setup Guide for more information about these menus.
Language Autoprogram
Select your menu language with
the cursor up/down.
Press the OK key on the remote
control to confirm.